Archive for EFSedan.com 1987 to 1991 Honda Civic Sedan Owners Club
 


       EFSedan.com Forum Index -> Write Ups & Tech Info
EFSS#17

Omni Power Coil Over Sleeve Install

I was given the OK from Omni Power to post this installation instruction.
Happy reading.



INCLUDED ITEMS FOR OMNI-POWER COILOVER KIT
Please inspect each item for defect prior to installation

● Four (4) Aluminum Threaded Sleeves With Aluminum Dual Locking Perches
● Four (4.) High Performance Coil Springs
● Two (2.) Steel Rings (For Front Assembly)
● Four (4.) Wide Rubber O-Rings
● Eight (8.) Medium Rubber O-Rings
● Eight (8.) Thin Rubber O-Rings
● Two (2.) Steel Spanner Adjustment Wrenches

INSTALLATION GUIDELINES

● Installation by a qualified / trained service technician is recommended.
● Refer to Factory Service Manual or Equivalent For Strut Removal Instructions and Diagrams
● Front assembly:
- Tap steel ring onto bottom of sleeve (non threaded part) so that it is secure
- Use 2 O-rings per strut placed between strut and sleeve to secure sleeve to strut. Use the O-rings that provide the most secure
fit. Secure O-rings with durable tape (duct).
- Place sleeve onto strut with steel ring at the bottom.
- Cut bump stop in half and replace on strut shaft.
- Place spring ending in -008 onto sleeve and reinstall upper shock perch.

Rear assembly:
- Use 2 O-rings per strut placed between strut and sleeve to secure sleeve to strut. Use the O-rings that provide the most secure
fit. Secure O-rings with durable tape (duct).
- Place sleeve onto strut with non threaded part at the bottom.
- Cut bump stop in half and replace on strut shaft.
- Place spring ending in -006 onto sleeve and reinstall upper shock perch.


● Vehicle Height Adjustment:
This Omni-Power Coilover Kit is designed to allow a wide range of vehicle height adjustments. Extreme lowering of the vehicle will cause
excessive negative camber, which will cause tires to wear unevenly and prematurely, and also place additional stress on other steering components
of the vehicle.

With the vehicle secure on jack stands or vehicle lift, turn the Aluminum Perches clockwise to raise, and counter clockwise to lower, with the
included adjustment wrenches. After adjusting height, secure lower perch against the upper perch by turning against each other, to prevent slippage.
Lower the vehicle and release brake to check ride height. To achieve desired ride height, you may need to repeat this process.

Vehicle toe and camber settings change with varying height adjustments. For proper steering and handling characteristics, a vehicle wheel alignment is highly recommended after complete installation and final height adjustment.

To provide maximum performance from this Coilover Kit, and to allow proper camber adjustments, Omni-Power Front and Rear Camber Kits are
recommended. They will allow proper and precise camber adjustment to your vehicle, which will enhance steering and handling dramatically, and
will reduce premature tire wear and reduce the additional stress placed on steering components from vehicle lowering.






www.omnipowerusa.com

       EFSedan.com Forum Index -> Write Ups & Tech Info
Page 1 of 1
Create your own free forum | Buy a domain to use with your forum