Archive for EFSedan.com 1987 to 1991 Honda Civic Sedan Owners Club
 


       EFSedan.com Forum Index -> Write Ups & Tech Info
Jerseys_fyn3st

DIY: how to mount jdm ef9 bumper with usdm support.

Well guys i pulled off my frnt bumper to instal a few things,  bare with me im doing this on my phone.

i started off by snatching up a Ef9 jdm front bumper but with no support. =( which sucked.

so i went online found some pics of a ef9 oem support because they are much different then usdm much.much different.

Here is jdm ef9 bumper support:






and heres your factory usdm sedan support.



So long story short you needa make your usdm support look almost as close to the jdm ef9 support as possible, i used a grinder with very good blades , and i didn't measure anything just cut little my little and continued to check if the usdm support  fit in the jdm bumper

Heres my support :

got it sitting perfect in the bumper.










Where my middle finger is at is my usdm cut support made to fit in that space where my index finger is =) enjoy fellas,

DO NOT I REPEAT DO NOT CUT OFF THE 12MM HOLES THAT HOLD THE BUMPER TO THE FRAME.!!!!!!! THERE ARE 2 ON EACH SIDE.


With some time on lining it up this is what it should like !!!! hope this helps everyoone!!!!

Jerseys_fyn3st

yea i could of bought a jdm support but it was 180$+ shipping , FOH!!!! lol i paid 100$ for the bumper so wasnt dropping more money on a support .
EF4lyf3

Great write up.  Cool  love the way you sedan sits to!!! Sticky FTW
4dred6

EF4lyf3 wrote:
Great write up.

       EFSedan.com Forum Index -> Write Ups & Tech Info
Page 1 of 1
Create your own free forum | Buy a domain to use with your forum